Need help?Do you have a question about the HP 3PAR StoreServ 7200 2-node and is the answer not in the manual?
Using SPOCC to access Guided Maintenance or SPMAINT for administrative and diagnostic tasks.
Instructions for replacing failed disk drives or solid-state drives (SSDs).
How to identify a failed drive using the HP 3PAR Management Console Summary tab.
Procedures for safely removing a 2.5-inch SFF disk drive from the enclosure.
Procedures for safely removing a 3.5-inch LFF disk drive from the enclosure.
Steps for installing both 2.5-inch SFF and 3.5-inch LFF disk drives.
How to confirm successful disk drive replacement and monitor status.
Comprehensive guide for replacing a controller node, including preparation and verification.
Steps to prepare for controller node replacement, including unpacking and ESD safety.
Procedures for identifying and safely shutting down a node before removal.
Detailed steps for physically removing a controller node from the system.
Instructions for installing a new controller node, including cable and SFP transfer.
Steps to verify successful installation and operation of the replaced controller node.
Procedures for manual setup and configuration when wizards are unavailable.
Step-by-step guide for the Out-of-the-Box (OOTB) script to set up storage system software.
Instructions for installing OS files onto the Service Processor.
Steps to add the storage system to the SP's configuration database.
Procedure for rescuing a storage system node using the Service Processor.
To Next Page
General
