HP 3PAR StoreServ 7000 Service Manual

HP 3PAR StoreServ 7000 Storage Service
Guide
Abstract
This guide is for qualified technicians who are authorized to perform installation, setup, maintenance, upgrade, and deinstallation
on the HP 3PAR StoreServ 7000 Storage system and hardware components.
HP Part Number: QR482-96026
Published: November 2012

HP 3PAR StoreServ 7000 Specifications

General

Brand	HP
Model	3PAR StoreServ 7000
Category	Storage
Language	English

Summary

Servicing the Storage System

Service Processor Onsite Customer Care

Use SPOCC for maintenance and diagnostic tasks on the storage system and Service Processor.

Identifying a Replaceable Part

Identifying Swappable Components

Explains component types (hot, warm, cold) based on touch points for replacement.

Getting Recommended Actions

Guide to find actions for alerts via the troubleshooting website.

Disk Drive Repair

Procedure to verify and repair failed disk drives using the console.

Removing a 2.5 inch Disk

Step-by-step guide for removing a 2.5 inch disk drive from the enclosure.

Removing a 3.5 inch Disk

Step-by-step guide for removing a 3.5 inch disk drive from the enclosure.

Installing a Disk Drive

Procedure for installing 2.5 and 3.5 inch disk drives into the enclosure.

Disk Drive Verification

Steps to verify successful disk replacement using the Management Console.

SFP Repair

Procedure to identify and repair failed SFPs using SPmaint CLI commands.

Replacing an SFP

Steps to disconnect, install, and reconnect an SFP module.

Understanding LED Indicator Status

Bezel LEDs

Disk Drive LEDs

Power Cooling Module LEDs

I/O Modules LEDs

Controller Node LEDs

FC Port LEDs

Fibre Channel Adapter Port LEDs

Converged Network Adapter Port LEDs

Installing Storage Software Manually

Connector Pin-outs

Manually Initializing the Storage System Software

Manually Setting up the Storage System

Steps for using the OOTB script for initial system setup.

Manually Setting up the Service Processor

High Speed Setup

Configuring the SP With Secure Network Mode

Mixed Connectivity Setup

Secure Site Setup

Installing HP 3PAR OS Files

Adding a Storage System to the Service Processor

Exporting Test LUNs

Defining Hosts

Creating and Exporting Test Volumes

Node Rescue

Service Processor (Physical) Node Rescue

Procedure for rescuing a physical SP node when it fails.