NOTE: To add a storage system, see “Adding a Storage System to the Service Processor”
(page 62).
24. Monitor the system while the SP uses the site key. When the system communications
configuration is complete, the following message appears:
(....)
*** starting final MOB phase
Fix passwords
enabling key change...
Disabling sendmail...
verifying postfix status...
Setup to run all ST/SP tasks at boot time
Cleanup MOB
Updating PAM settings
Rebooting....
The SP restarts.
Continue to “Installing HP 3PAR OS Files ” (page 61).
Installing HP 3PAR OS Files
After completing the Service Processor Setup wizard process, HP 3PAR OS files must first be
installed onto the SP in order to communicate and add a storage system.
To install the OS files:
1. Insert the HP 3PAR OS Release Distribution CD into the SP.
2. Log in to the SP as spvar (password prompted).
3. In the SPMaint main menu, type:
• 1 for SP Control/Status
• 16 for Maintain SP Software
• 1 for Update SP Software Revision
• 2 for CDROM to install the files.
NOTE: The installation process takes approximately five minutes.
4. When prompted to update the SP, verify that the software version is correct. Type y and press
ENTER to continue with the update process.
Mounting CDROM...
Using spinstaller from /sp/sw/sp/2.5.1.GA-15/
tpdSPInFormOS3.1.2.226-3.1.2.226-12.i386.rpm
Do You wish to update the SP from /mnt/cdrom?
(y or n)
y
5. When the installation process completes, the SPMaint main menu reappears. To verify the
current software versions after installation, type 1 for SP Control/Status.
1 SP Main
3PAR Service Processor Menu
Transfer media: ethernet Transfer status: Ok
Installing HP 3PAR OS Files 61
To Next Page
Loading...
