HP 3PAR StoreServ 7000 - Adding a Storage System to the Service Processor

To Next Page

To Previous Page

Enter Control-C at any time to abort this process

1 ==> SP Control/Status

2 ==> Network Configuration

3 ==> InServ Configuration Management

4 ==> InServ Product Maintenance

5 ==> Local Notification Configuration

6 ==> Site Authentication Key Manipulation

7 ==> Interactive CLI for an InServ

X Exit

6. Type 1 for Display SP Version to verify installation is complete.

1.1 Display SP Version

SP Software Version

SP-2.5.1.GA-15

SP Base Image Version: 3.1-8

SP Version: 2.5.1.GA-15

SP Patches:

InFormOS release (3.1.2): 3.1.2.226

More detail is available in the latest SPLOR or spconfig data.

Press <enter/return> to continue

Continue to “Adding a Storage System to the Service Processor” (page 62).

Adding a Storage System to the Service Processor

After successfully completing the Service Processor Setup Wizard, you must add the storage system

to the configuration database of the SP. Adding the storage system permits the SP to communicate,

service, and monitor the health of the system.

To add the storage system to the SP:

1. Connect the maintenance PC to the SP.

2. In the SPMaint, type 3 and press ENTER to select InServ Configuration Management.

SPXXXXX

1 SP Main

3PAR Service Processor Menu

Transfer media: ethernet Transfer status: No transfer yet