Installing a Disk Drive
CAUTION: Blank disk drive carriers are provided and must be used if all slots in the enclosure
are not filled with disk drives.
CAUTION: To avoid potential damage to equipment and loss of data, handle disk drives carefully.
NOTE: Before beginning this procedure, review how to load the drives based on drive type,
speed, and capacity. For more information, see the HP 3PAR StoreServ 7000 Storage Installation
Guide.
To install a 2.5 inch disk drive (see Figure 10 (page 13)):
1. Press the handle latch to open the handle.
2. Insert the disk drive into the enclosure with the handle opened from the top in the vertical
position.
3. Slide the disk drive into the enclosure until it engages and push firmly until it clicks.
Figure 10 Installing a 2.5 inch disk drive
To install a 3.5 inch disk drive (see Figure 11 (page 14)):
1. Press the handle latch to open the handle.
2. Position the disk drive so the handle opens from the left and slide it into the enclosure.
3. Push firmly until the handle fully engages and clicks.
Disk Drive Repair 13
To Next Page
Loading...
