Creating and Exporting Test Volumes
For more information about the commands used in this section, see the HP 3PAR OS Command
Line Interface Reference.
To create and export test volumes:
1. In the CLI, create a common provisioning group test to verify the system can create and export
virtual volumes.
192.168.46.249 cli% createcpg test_cpg
2. Create a virtual volume.
192.168.46.249 cli% createvv <usr_CPG> test0 256
3. Create a VLUN of the virtual volume for export to the host.
192.168.46.249 cli% createvlun test0 0 <hostname>
4. Verify that the host can access the VLUN.
5. Repeat steps 1 through 4 for each host.
6. From the SP, type exit to stop the CLI session, then type x and press ENTER to return to the
SP main menu. Type x and press ENTER again to exit. Type exit and press ENTER to log off
the SP. Disconnect the cables between the SP and the maintenance PC.
Exporting Test LUNs 65
To Next Page
Loading...
