Figure 11 Installing a 3.5 inch disk drive
Disk Drive Verification
1. Verify that the Disk Drive has been successfully replaced.
2. Redisplay the physical disks to monitor. Open the system in the Systems tab and select Physical
Disks.
NOTE: Users can select the column header State to re-sort.
The original disk drive displays as Failed and the replacement drive displays as Degraded.
The new drive displays in the same position as the failed drive and the State is listed as
Normal.
NOTE: The drive that was replaced continues to display in the table as Failed until the
disk rebuild is complete, which may take several hours. When the process is complete the
failed drive is dismissed and dropped from the display.
14 Servicing the Storage System
To Next Page
Loading...
