HP t510 - Installing Thin Client Options; Installing the USB Device

Installing Thin Client Options
Various options can be installed on the thin client:
●
Installing the USB Device on page 15
●
Removing and Replacing the Battery on page 16
●
Installing a Secondary Flash Memory Module on page 18
●
External Drives on page 19
Installing the USB Device
Before beginning the replacement process, review General Hardware Installation Sequence
on page 10 for procedures you should follow before and after installing or replacing hardware.
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Figure 2-6 USB ports in the secure USB compartment
Installing Thin Client Options
15