Improve copy quality
If print quality problems occur only in copied documents, try these solutions.
●
Make sure the copy settings on the product control panel are adjusted for the type of document and
paper you are using.
●
Make sure the camera arm is raised completely.
NOTE: Do not touch the camera arm during the copy process. Due to its sensitivity, camera-arm
movement can cause image quality problems.
Clean the camera lens cover
If the print quality on the copied pages is not acceptable, clean the cover over the camera lens with a soft
cloth or sponge that has been moistened with nonabrasive glass cleaner.
CAUTION: Do not use abrasives, acetone, benzene, ammonia, ethyl alcohol, or carbon tetrachloride
on any part of the product; these can damage the product. Do not place liquids directly on the capture
stage. They might seep and damage the product.
Solve problems with cropped copies
The product cannot print fully edge-to-edge. The maximum printing area is 203.2 x 347 mm (8 x 13.7 in),
leaving a 4 mm (1/6 in) unprintable border around the page.
●
When the original is smaller than the output size, move the original 4 mm (1/6 in) away from the
corner of the capture stage. Recopy in this position.
●
When the original is the size of the desired output, use the Reduce/Enlarge feature to reduce the
image so the copy is not cropped.
ENWW
Improve copy quality
161
To Next Page
Loading...
