© Copyright 2015 HP Development Company, L.P. All rights reserved.
The information contained herein is subject to change without notice. The only warranties for HP products and services are set
forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as
constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. All
specifications represent the typical specifications provided by HP's component manufacturers; actual performance may vary
either higher or lower.
ENERGY STAR is a registered trademark of the U.S. Environmental Protection Agency.
1. External power supplies, power cords, cables and peripherals are not Low Halogen. Service parts obtained after purchase may not be
Low Halogen.
2. EPEAT® registered where applicable. EPEAT registration varies by country. See www.epeat.net for registration status by country.
3. Service levels and response times for HP Care Packs may vary depending on your geographic location. Service starts on date of
hardware purchase. Restrictions and limitations apply. For details, visit www.hp.com/go/cpc. HP services are governed by the
applicable HP terms and conditions of service provided or indicated to Customer at the time of purchase. Customer may have additional
statutory rights according to applicable local laws, and such rights are not in any way affected by the HP terms and conditions of service
or the HP Limited Warranty provided with your HP Product.
4. The HP Quick Release has been designed to support a maximum of up to 24 lbs (10.9 kg) for all devices mounted. Because mounting
surfaces vary widely and the final mounting method and configuration may vary, mounting fasteners are not supplied (other than the
VESA-compliant screws). HP recommends that you consult with a qualified engineering, architectural or construction professional to
determine the appropriate type and quantity of mounting fasteners required for your application and to ensure that your mounting
solution is properly installed to support applied loads.
To Next Page
Loading...
Need help?
General
