3) Lift the CN301 connector from the circuit board.
4) Place the new component on the circuit board. Be sure that it matches the footprint.
5) Solder the new component.
DP connector CN401
Repair the DP connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
DP connector repairing
2) Use a hot air gun to melt the solder on the pins.
DP connector repairing
3) Lift the CN401 connector from the circuit board.
4) Place the new component on the circuit board. Be sure that it matches the footprint.
5) Solder the new component.
To Next Page
Loading...
