16
HDMI connector P102
Repair the HDMI connector:
3) Use a soldering iron and a desoldering pump to remove as much solder as possible from the pin.
4) Use a hot air gun to melt the solder on the pins.
5) Lift the P102 connector from the PCB.
6) Place the new component on the PCB. Be sure that it matches the PCB footprint.
7) Solder the new component.
DC connector P103
Repair the DC connector:
8) Use a soldering iron and a desoldering pump to remove as much solder as possible from the pin.
To Next Page
Loading...
