TIP: To list all available SAC commands, enter ? or help at the SAC prompt.
To list the subset of SAC commands available for managing command channels, enter: SAC> ch
-?
SAC also provides access to the setup logs during GUI-mode setup. Press ESC+TAB to switch
between the setup logs and SAC. When accessing the setup logs from EMS, you can see which
portions have completed and whether any errors have occurred. This is a useful way to check the
progress of your setup and to diagnose setup failures.
The setup log channels are as follows:
setuplog.txt Monitors setup progress.
setupact.log Displays any warnings during setup.
setuperr.log Displays any errors that might occur during setup.
SAC Channel Management Commands
Table 2 lists the channel management commands.
Table 2 Channel Management commands
FunctionCommand
Lists all channels.ch
Changes to the channel with the number, n, which you
specify.
ch -si n
Changes to the channel with the name you specify.ch -sn name
Closes the channel with the number, n, which you specify.ch -ci n
Closes the channel with the name you specify.ch -cn name
Switches channels.Esc + Tab
Returns to the SAC channel.Esc + Tab + 0
Displays the channel-management commands Help.ch -?
SAC Channel Management Commands 17
To Next Page
Loading...
Need help?
General