Need help?Do you have a question about the HP Carrier-Grade rx2800 i2 Server DC and is the answer not in the manual?
General| Form Factor | 2U Rack |
|---|---|
| Product Type | Carrier-grade server |
| Memory Type | DDR3 |
| Hard Drive Interface | SAS |
| Storage | Up to 8x 2.5-inch SAS HDDs/SSDs |
| Power Supply | Redundant Power Supplies |
| Operating System | HP-UX |
| Operating System Support | HP-UX |
| Processor | Intel Itanium Processor 9300 series |
| Memory | Up to 384 GB (24 DIMM slots) |
Explains precautions to prevent damage from static electricity.
Describes methods for powering the server on.
Details procedures for powering the server off.
Guides through installing the operating system on the server.
Details the process of installing a server processor.
Procedure for installing a processor with its heat sink module.
Presents a preferred methodology for troubleshooting server issues.
Provides a step-by-step recommended troubleshooting approach.
Lists and describes tools used for server troubleshooting.
Provides instructions on how to consult and use event logs.
Outlines the methodology for troubleshooting installation issues.
Explains how to use the server power button for troubleshooting.
Addresses issues where the server does not power on.
Details troubleshooting steps for server processors.
Guides on identifying and troubleshooting firmware problems.
Highlights safety precautions before performing procedures.
Describes how to safely power off the server.
Procedure for removing and replacing the system board.
Overview of the Unified Extensible Firmware Interface (UEFI).
To Next Page