EasyManuals Logo

HP Carrier-Grade rx2800 i2 Server DC User Manual

HP Carrier-Grade rx2800 i2 Server DC
149 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
Set mode
IMPORTANT: If you are using HBA mode, do not install any disk that has previously been a part
of a RAID volume into the system.
Set mode is used to change the mode of the controller. If the controller is already in the required
mode the following message appears:
The controller at seg:bus:dev:funcis already in HBA|RAID mode.
Syntax
saupdate set mode <controller> <hba | raid> [-f]
<controller> can be any one of the strings listed in Table 41 (page 130).
An alert message about the possible data loss is displayed when a mode change command is
issued. A confirmation is required before the actual mode change is made. This ensures unintentional
change of mode does not happen.
The -f option indicates the user is aware of the changes that are being made and does not require
a warning message or a confirmation regarding the mode change.
IMPORTANT: After changing the mode, perform a reconnect -r command at UEFI.
NOTE: Commands are not case-sensitive.
Updating the firmware using saupdate
1. Download the firmware image file into the system UEFI partition.
2. Boot the system to the UEFI Shell and change directories to the UEFI partition.
3. Use the saupdate list to display all detected Smart Array controllers along with the active
firmware versions, the identification information from this list is used to designate which
controller is to be updated.
4. Use saupdate update <seg:bus:dev:func:index> <firmware image> to update
the firmware.
5. Restart the system.
To query the current mode of the controller usesaupdate get_mode <controller>. The
<controller> could be any one of the strings:
<seg:bus:dev:func> A controller having the PCI segment id, bus id, device id and function
id is addressed
all Addresses all controllers in the system
<model> Controllers of a particular type indicated by the <model) string are addressed.
SAS disk setup 131

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Carrier-Grade rx2800 i2 Server DC and is the answer not in the manual?

HP Carrier-Grade rx2800 i2 Server DC Specifications

General IconGeneral
Form Factor2U Rack
Product TypeCarrier-grade server
Memory TypeDDR3
Hard Drive InterfaceSAS
StorageUp to 8x 2.5-inch SAS HDDs/SSDs
Power SupplyRedundant Power Supplies
Operating SystemHP-UX
Operating System SupportHP-UX
ProcessorIntel Itanium Processor 9300 series
MemoryUp to 384 GB (24 DIMM slots)

Related product manuals