What to do if HP SimpliVity OmniCube CN-3400 Server accelerator card is not detected?
If the HP Server's accelerator card isn't being detected, a firmware load error on the card might be the cause. To resolve this, shut down the server, wait three minutes for it to fully shut down, and then restart the server.
What to do if HP SimpliVity OmniCube CN-3400 Server drive fails?
If a drive fails or is failing, contact Customer Support to obtain a replacement drive of the same type, size, and speed.
What to do if HP SimpliVity OmniCube CN-3400 network interface card (NIC) fails?
If a network interface fails, contact Customer Support to have it replaced.
What to do if HP SimpliVity OmniCube CN-3400 Server power supply fails?
If a power supply fails, contact Customer Support for a replacement of the same type and wattage.
Details hardware configurations for SimpliVity OmniCube models, including CPU, memory, drives, and power specifications.
Explains essential ESD protection measures to prevent hardware damage during installation and handling.
Details unpacking the server carton and installing the enclosure into a rack using sliding rails.
Provides steps to access the IPMI web GUI and launch the Virtual Console for system management and advanced options.
Guides on accessing the PERC BIOS Configuration Utility to manage drive security and encryption settings.
Details checking drive security status in BIOS and IPMI, and managing security keys and disk groups.
Explains how to erase encrypted drives, permanently removing security attributes after deleting secured disks.
General| Model | OmniCube CN-3400 |
|---|---|
| Product Type | Hyperconverged Infrastructure Appliance |
| Form Factor | 2U Rackmount |
| Memory | Up to 512 GB DDR4 |
| Power Supply | Dual redundant power supplies |
| Hypervisor Support | VMware vSphere |
| Processor | Intel Xeon E5-2600 v3 series |
| Data Services | Deduplication, Compression, Backup |
To Next Page