24 Organize the cables
Figure 8: Connect the power cables
3. Use the cable strain relief (hook and loop fastener) on each power supply to secure the power cable
and prevent an accidental disconnection.
Figure 9: Securing the power cables
Next steps
You can now connect the network cables.
Organize the cables
Procedure overview
If you do not want to use the cable management arm (CMA), use the two hook and loop straps provided in
the rail kit to organize the power and network cables.
NOTE:
Make sure you have sufficient slack in the cables to fully extend the enclosure from the rack until
the rails are safely locked in the extended position.
Procedure
1. Insert the outer CMA brackets on the interior sides of both rack flanges.
To Next Page
Loading...
