Power on the system 25
2. Gather the cables on each side of the enclosure into bundles.
3. Thread the hook and loop straps through the tooled slots on the outer CMA brackets on each side of
the enclosure and secure the cable bundles.
For more information, see the Cable Management Arm Installation Instructions supplied in the cable
management kit.
Power on the system
Press the power button on the front panel of each OmniCube server to apply power to the device.
Procedure
1. Go to the front panel of the system.
2. Press the power button to power-on the system.
3. Check that the health indicator on the front panel changes from flashing amber to steady blue within
approximately 4 minutes.
4. Check that the two LEDs on the Accelerator card at the rear of the system are steady green.
Attach the OmniCube bezel
You attach the OmniCube bezel to the front panel of the system to physically secure the front drives,
ensure proper airflow, and to prevent accidental removal of drives.
Procedure overview
Note the following information before performing the procedure.
NOTE:
To avoid damaging the bezel decals, be sure to remove the bezel from the open end of its
protective wrap rather than the taped end.
Procedure
1. Identify the front panel mounting lugs on the right side of the system.
To Next Page
Loading...
