HP Carrier-Grade rx2800 i2 Server DC User Manual

2. Extend the server from the rack.
WARNING! To reduce the risk of personal injury or equipment damage, be sure that the
rack is adequately stabilized before extending a component from the rack.
3. After performing the installation or maintenance procedure, slide the server back into the rack,
and then press the server firmly into the rack to secure it in place.
WARNING! To reduce the risk of personal injury, be careful when pressing the server
rail-release latches and sliding the server into the rack. The sliding rails might pinch your
fingers.
Powering off the server
WARNING! To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until DC power is removed.
94 Removal and replacement procedures

HP Carrier-Grade rx2800 i2 Server DC Specifications

General

Form Factor	2U Rack
Product Type	Carrier-grade server
Memory Type	DDR3
Hard Drive Interface	SAS
Storage	Up to 8x 2.5-inch SAS HDDs/SSDs
Power Supply	Redundant Power Supplies
Operating System	HP-UX
Operating System Support	HP-UX
Processor	Intel Itanium Processor 9300 series
Memory	Up to 384 GB (24 DIMM slots)