HP XP P9500

| |
| Specify or revise the following values. |
| |
| Device number . : 8000 Number of devices . . . . : 128 |
| Device type . . : 3390B |
| Processor ID . . : PROD |
| |
| Unit address . . . . . . . . . . 00 + (Only necessary when different from |
| the last 2 digits of device number) |
| Time-Out . . . . . . . . . . . . No (Yes or No) |
| STADET . . . . . . . . . . . . . Yes (Yes or No) |
| |
| Preferred CHPID . . . . . . . . __ + |
| Explicit device candidate list . No (Yes or No) |
| |
| F1=Help F2=Split F3=Exit F4=Prompt F5=Reset F9=Swap |
| F12=Cancel |
'-----------------------------------------------------------------------------'
14. On the Define Processor / Definition panel, verify that the proper values are displayed, and
press Enter.
.-------------------- Device / Processor Definition --------------------.
| Row 1 of 1 |
| Command ===> _____________________________________ Scroll ===> PAGE |
| |
| Select processors to change device/processor definitions, then press |
| Enter. |
| |
| Device number . . : 8000 Number of devices . : 128 |
| Device type . . . : 3390B |
| |
| Preferred Explicit Device |
| / Processor ID UA + Time-Out STADET CHPID + Candidate List |
| _ PROD 00 No Yes __ No |
| ************************** Bottom of data *************************** |
| |
| |
| |
| |
| |
| |
| |
| F1=Help F2=Split F3=Exit F4=Prompt F5=Reset |
| F6=Previous F7=Backward F8=Forward F9=Swap F12=Cancel |
'-----------------------------------------------------------------------'
15. On the Define Device to Operating System Configuration panel, input an S next to the Config
ID, and then press Enter.
.----------- Define Device to Operating System Configuration -----------.
| Row 1 of 1 |
| Command ===> _____________________________________ Scroll ===> PAGE |
| |
| Select OSs to connect or disconnect devices, then press Enter. |
| |
| Device number . : 8100 Number of devices : 128 |
| Device type . . : 3390B |
| |
| / Config. ID Type Description Defined |
| s PROD MVS |
| ************************** Bottom of data *************************** |
| |
| |
| |
| |
| |
| |
| |
| |
| F1=Help F2=Split F3=Exit F4=Prompt F5=Reset |
| F6=Previous F7=Backward F8=Forward F9=Swap F12=Cancel |
'-----------------------------------------------------------------------'
16. The Define Device Parameters / Features panel displays the default device parameters. The
WLMPAV parameter defaults to YES. Set the parameters, and then press Enter.
.-------------------- Define Device Parameters / Features --------------------.
| Row 1 of 6 |
| Command ===> ___________________________________________ Scroll ===> PAGE |
| |
| Specify or revise the values . |
| |
| Configuration ID . : PROD |
| Device number . . : 8000 Number of devices : 128 |
| Device type . . . : 3390B |
| |
| Parameter/ |
| Feature Value P Req. Description |
| OFFLINE No Device considered online or offline at IPL |
| DYNAMIC Yes Device supports dynamic configuration |
Mainframe hardware definition 27