• Create as many logical volumes as you need using the following command: lvcreate
--size 16G fcpvg
• Enable the alternate paths to the physical volumes using the pvpath command: pvpath
--path0 --enable y /dev/sda1 pvpath --path1 --enable y /dev/sda1.
If both paths are set to a weight of 0, they will load balance.
4. These configurations yield the SCSI device /dev/sda - /dev/sdc, This device is accessible
on the first path and the SCSI device /dev/sdd - /dev/sdf accessed on the second path.
Attaching FCP adapters to zSeries hosts running Linux 37
To Next Page
Loading...
