3. To connect the first four hard drives:
a. Attach the coupled end of the data cable to Internal connector 1 on the RAID controller
.
b. Attach the four splitter cables on the other end of the data cable to the data cable connectors
on the hard drives
2
.
c. To connect power to the hard drives, see the hard drive product documentation.
Figure 8 Data cable connections
4. If connecting more than four hard drives, attach the second data cable supplied with the controller
card kit to Internal connector 2 on the controller card.
10 LSI MegaRAID® SAS 8888ELP Host Bus Adapter installation ENWW
To Next Page
Loading...
