EasyManuals Logo

HP xw4600 Quickspecs

HP xw4600
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
PC2-5300E DDR2-667 ECC Unbuffered or PC2-6400E DDR2-800 ECC Unbuffered RAM DIMMs
Only Error Checking and Correcting unbuffered DDR2 DIMMs are supported and must be either x8 or x16 width. Memory
upgrades are accomplished by adding DIMMs of the same or varied sizes. The Intel chipset supports both PC2-5300 DDR2-
667 and the PC2-6400E DDR2-800 ECC unbuffered memory. It is suggested to not mix ECC and non-ECC memory.
For best performance the total amount and type of memory loaded into Channel A and Channel B should be the same. If it is
not, your computer will see all the RAM installed but will run the memory controller at a lower performance mode. Although
not required, for best performance add the memory in pairs rather than as a single DIMM (two 512 MB DIMMs will have
better performance than a single 1 GB DIMM). Also, add the memory into both channels (e.g. one in socket 1 and one in
socket 3) to take advantage of dual channel performance. If you have unused slots within a channel, make them socket 2
and socket 4. This provides the best margin for the memory bus. If you are only using 1 DIMM, install it in socket 1.
MAXIMUM MEMORY
Supports up to 8 GB DDR2-667 or DDR2-800 ECC unbuffered memory
POSSIBLE MEMORY CONFIGURATIONS
Not all memory configurations possible are represented below. Please install memory in pairs. Configurations using three
DIMMs are not supported by HP.
DIMM Size
Slot
1 2 3 4
512 MB
(single channel performance
configuration)
512 MB
1 GB
512 MB 512 MB
2 GB 1 GB 1 GB
2 GB
512 MB 512 MB 512 MB 512 MB
4 GB 1 GB 1 GB 1 GB 1 GB
4 GB 2 GB 2 GB
6 GB 1 GB 2 GB 1 GB 2 GB
8 GB 2 GB 2 GB 2 GB 2 GB
QuickSpecs
HP xw4600 Workstation
Memory
DA - 12792 Worldwide QuickSpecs — Version 19 — 9.12.2008
Page 15

Other manuals for HP xw4600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP xw4600 and is the answer not in the manual?

HP xw4600 Specifications

General IconGeneral
Tcase72.4 °C
Bus typeFSB
SteppingE0
Processor cache6 MB
Processor cores2
Processor modelE8400
System bus rate- GT/s
Processor familyIntel® Core™2 Duo
Processor seriesIntel Core 2 Duo E8000 Series
Processor socketLGA 775 (Socket T)
Processor codenameWolfdale
Processing Die size107 mm²
Processor frequency3 GHz
Processor cache typeL2
Processor lithography45 nm
Processor manufacturerIntel
Processor front side bus1333 MHz
Processor operating modes64-bit
ECC supported by processorNo
Thermal Design Power (TDP)65 W
Number of processors installed1
CPU multiplier (bus/core ratio)9
Number of Processing Die Transistors410 M
Audio systemHigh Definition Audio
Product typeWorkstation
Motherboard chipsetIntel® X38 Express
ECCYes
Internal memory2 GB
Memory clock speed800 MHz
Internal memory typeDDR2-SDRAM
Maximum internal memory8 GB
Memory layout (slots x size)2 x 1 GB
HDD speed7200 RPM
HDD capacity250 GB
HDD interfaceSATA
Optical drive typeDVD-RW
Graphics card-
Networking featuresGigabit Ethernet (10/100/1000)
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power supply475 W
Chassis typeTower
Country of originChina
Processor codeSLB9J
Processor ARK ID33910
Processor package size37.5 x 37.5 mm
On-board graphics card modelNot available
Weight and Dimensions IconWeight and Dimensions
Depth456 mm
Width168 mm
Height450 mm
Weight19000 g

Related product manuals