Figure 4-11 Removing the power supply
To install the power supply, reverse the previous steps.
System/memory fan assembly
The system fan and memory fan are connected and treated as a unit. To remove the system/memory
fan assembly:
1. Disconnect power from the system (
Pre-disassembly procedures on page 55), and remove the
access panel (
Access panel on page 60). Place the workstation on its side with the system board
facing up.
2. Press the green tab (2) at the base of the memory fan, and lift it up.
3. Disconnect the system fan and memory fan power plugs from their system board connectors (1).
66 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
