HP Z440

Screen message Probable cause Recommended action
4. Remove and replace memory modules one at a time
to isolate faulty modules.
5. Replace faulty memory modules.
6. If the error persists after replacing memory
modules, replace the system board.
214—DIMM Conguration
Warning
DIMMs are not installed correctly (not
paired correctly).
See the service label on the computer access panel for the
correct memory congurations, and reseat the DIMMs
accordingly.
301—Keyboard Error Keyboard failure. 1. Reconnect the keyboard with the computer
powered o.
2. Connect a keyboard directly to the computer (instead
of through a switch box).
3. Be sure that none of the keys are pressed.
4. Replace the keyboard.
303—Keyboard Controller Error I/O board keyboard controller is
defective or is not set properly.
1. Reconnect the keyboard with the computer powered
o.
2. Connect a keyboard directly to the computer (instead
of through a switch box).
3. Replace the system board.
304—Keyboard or System Unit
Error
Keyboard failure. 1. Reconnect the keyboard with the computer powered
o.
2. Connect a keyboard directly to the computer (instead
of through a switch box).
3. Be sure that none of the keys are pressed.
4. Replace keyboard.
5. Replace system board.
510—Splash Screen image
corrupted
Splash Screen image has errors. Update system BIOS/UEFI.
511—CPU Fan not detected Fan is not connected or is defective. 1. Reseat the fan cable.
2. Reseat the fan.
3. Replace the fan.
512—Rear chassis fan not
detected
Fan missing, disconnected, or defective. 1. Reseat the fan cable.
2. Reseat the fan.
3. Replace the fan.
513—Front Chassis fan not
detected
Front fan missing, disconnected, or
defective.
1. Reseat the fan cable.
2. Reseat the fan.
3. Replace the fan.
514—Power supply wattage
insucient for hardware
conguration
Computer conguration requires more
power than the power supply can
provide
Reduce the computer power consumption.
515—Power supply fan not
detected
Power supply fan is disconnected or
defective.
1. Reseat the power supply cables.
2. Replace the power supply.
Diagnostic codes and errors 95