HP Z440 - Recovery using Windows 8 restore media

Heading Option Description
◦
Hard Drive
— USB Hard Drive
— Hard Drive Name
◦
Network Controller (This option is available only if the workstation is
connected to a network.)
Use the arrow keys to move the cursor to a listed device, and then perform one of the
following actions:
●
Press Enter to select or deselect the device.
●
Use the arrow keys to move a selected device up or down in the boot order. Press
F10 to accept the new boot order.
●
For a selected device, press F5 to enable or disable it as a bootable device.
MS-DOS drive lettering assignments might not apply after an operating system other
than MS-DOS has started.
Boot devices can be disabled in the boot order process. These order changes are stored
in the physical ROM when the F10 Setup changes are conrmed. Select Main, select Save
Changes, and then select Exit.
You can temporarily override the boot order. To start one time from a device other than
the default device specied in Boot Order, restart the workstation and press F9 when the
F9=Boot Menu message appears on the screen. After POST completes, a list of bootable
devices is displayed. Use the arrow keys to select the preferred bootable device, and
then press Enter. The workstation then starts from the selected non-default device for
this one time.
Device Congurations Lists installed storage devices and provides options for obtaining specic information
about each device:
To see additional information about a device, use the Up and Down arrow keys to see a
device and press Enter to show additional details about the device if available.
Hard Disk
●
SATA0 <DRIVE CAPACITY>, <DRIVE MFG and/or MODEL> (If installed)
●
SATA1 <DRIVE CAPACITY>, <DRIVE MFG and/or MODEL> (If installed)
●
SATA5 <DRIVE CAPACITY>, <mSATA DRIVE MFG and/or MODEL> (If mSATA installed
in SLOT2)
CD-ROM
●
SATA2 <MFG MODEL> (If installed)
Secure Boot
Conguration
●
Legacy Support—(Enable/Disable)
●
Secure Boot—(Enable/Disable)
●
Key Management
◦
Clear Secure Boot Keys—(Clear/Don't Clear)
◦
Key Ownership—(HP Keys/Custom Keys)
●
Fast Boot—(Enable/Disable)
For more information on secure boot management go to http://h10025.www1.hp.com/
ewfrf/wc/document?docname=c03653226&cc=us&dlc=en&lc=en.
Power Options Enables you to set the following:
●
Operating System Power Options
30 Chapter 2 System management