7
4/28/2017 860-EI
High / Low Models: Antenna Extension Cable Mounting (cont’d)
If using the antenna extension cable is not possible, remove from fire pit insert and reinstall antenna.
For best results the antenna should be pointed down as much as possible depending on the configuration and the
onsite conditions. Be careful not to damage the antenna during installation or service.
6. Media Application
WARNING: FOR GLASS MEDIA USAGE WITH LP GAS- WHEN USING APPROVED DECORATIVE GLASS TO
COVER BURNER APPLY ONLY ENOUGH TO HIDE BURNER. APPLYING OVER 1/2” MAY CREATE BACK
PRESSURE AND GAS LEAKAGE FROM AIR MIXER RESULTING IN LP POOLING UNDER FIRE PIT.
WARNING: FOR GLASS MEDIA USAGE WITH LP GAS- THE UNIT MUST BE TESTED WITH MEDIA OVER
BURNER FOR CONFIRMATION OF NO BACK PRESSURE CREATING GAS TO LEAK OUT OF AIR MIXER
VENTURI HOLES. THIS MAY HAVE TO BE DONE PRIOR TO PLACING IN ENCLOSURE IF NO ACCESS DOOR.
x The fire pit is designed to use approved media correctly installed over the burner to achieve proper combustion.
x Never install a mesh or screen under the media.
x Never use any material that is non-porous and holds moisture such as gravel, pebbles, river rock, etc. This
material is not sufficiently porous to allow heated steam to readily escape which can break and cause personal
injury or damage.
x Media affects flame pattern greatly. It is possible to create an unusual flame pattern that could damage your
enclosure. Enclosure damage from an open flame fire feature is not covered under any warranty.
x The use of concrete logs is not recommended.
Valve Box Side
Mount –
Round, Square,
Rectangular Inserts
Valve Box Vertical Mount -
Linear Inserts
To Next Page
Loading...