HPE Aruba 2930F 24G

Hot Swapping SFP/SFP+ transceivers
Supported SFP/SFP+ transceivers that you can install in your HPE Aruba switch can be “hot
swapped” – removed and installed while the switch is receiving power. However, you should
disconnect the network cables from the SFP/SFP+ transceivers before hot-swapping them.
When you replace an SFP/SFP+ transceiver with another of a different type, the switch may
retain selected port-specific configuration settings that were configured for the replaced unit. Be
sure to validate or reconfigure port settings as required.
SFP/SFP+ connections to devices with fixed speed/duplex configurations
When connecting a device to your switch port that contains an SFP/SFP+ transceiver, the speed
and duplex settings of the switch port and the connected device must match. Otherwise, you
may not get a link. For some older network devices, including some older Hewlett Packard
Enterprise devices, the default speed/duplex settings may be predefined (for example, to 1000
Mbps/Full Duplex), or otherwise set differently from the default configuration of your switch port.
Because of these default speed/duplex considerations, you should make sure that devices
connected to your SFP/SFP+ ports are properly configured. At a minimum, make sure the
configurations match.
Switch Operating System Software
For the latest software version supported by your switch, visit http://www.hpe.com/networking/
support.
For software installation and management, the Basic Operation Guide and other software
documentation for your switch at www.hpe.com/networking/ResourceCenter.
Regulatory information
For important safety, environmental, and regulatory information, see Safety and Compliance
Information for Server, Storage, Power, Networking, and Rack Products, available at http://
www.hpe.com/support/Safety-Compliance-EnterpriseProducts.
Power cords
Use one of the following power cords for an Aruba 2930F switch:
8121–1004Israel8121–0729Argentina
8121–1143Japan8121-0837Australia/New Zealand
8121–0738Switzerland8121-1071Brazil
8121–0737South Africa8121–0735Chile
8121-0964Taiwan8121–0943China
8121-0734Philippines/Thailand8121–0731Continental Europe/South
Korea
8121–0739UK/Hong Kong/Singapore/Malaysia8121–0733Denmark
8121-1141US/Canada/Mexico8121–0564India
10 Aruba 2930F 24G/48G Switch Quick Setup Guide and Safety/Regulatory Information