HPE Cloudline CL2200 Gen10 - Page 49

Cause
 Real-time clock system battery is running low on power or lost power.
Action
 Replace the battery.
4-3-7 System board or PDB issue
Symptom
 A POST message or BMC WebUI message is received indicating an issue with either the system board
or the PDB.
Action
 Review all error messages for possible issues with other components and troubleshoot components
identified.
 Verify that no loose connections exist on the system board or PDB. It is not necessary to reseat
processors.
 Remove any components recently added.
 Power down and remove all power from the server. Remove the system battery for 10 minutes.
 Reinstall the battery and power on the server.
 Gather necessary information and contact support.
4-3-8 USB drive key issue
System does not boot from the USB drive key
Symptom
 The system does not boot from the USB drive key.
Cause
 The USB drive key is not enabled in the UEFI System Utilities.
 The drive boot order is not set to boot from the USB drive key.
 The USB drive key is not seated properly.
Action
 Be sure that USB is enabled in the UEFI System Utilities.
 Be sure the drive boot order in the BIOS Setup Menu is set so that the server boots from the USB drive
key.