INSTALLATION (continued) PAGE 17
_____________________________________________________________________________________________________________________________________________________________________________________
Jacket and Door Assembly (continued)
Your jacket and doors are now fully assembled!
NOTE: LOADING DOOR SMOKE FLAP. Tarm USA, Inc. recommends that the heavy āCā
shaped smoke flap not be permanently installed in the door opening: Doing so
may damage the door over time. If you have smoke spillage when loading wood,
place the smoke flap in the door opening and remove it before closing the door.
If your boiler is installed with a Heat Storage System, you may be able to mount
the smoke flap permanently without problems. However, do not allow creosote
build-up to occur on the load door behind the smoke flap.
17
To Next Page
Loading...