Control Direction Tests
After binding a transmitter to the aircraft receiver, set the trims and
center the control surfaces.
sub-trims to 0,then adjust the clevises to
Move the controls on the transmitter to make sure the aircraft control surfaces move in the proper direction.
Assemble the aircraft and bind your transmitter to the receiver before performing this test.
Transmitter
Command
Aircraft Reaction
Elevator
Up Elevator
Command
Down
Elevator
Command
Aileron
Stick Right
Stick Left
Rudder
Stick Right
Stick Left
Small
Big
the Throttle
the Landing
gear
08
According to everyone's operating
habit, the position of switch can be
chosen on the premise of optional
remote control switch.
To Next Page
Loading...
