HSM classic User Manual

5. Start-up
Switching the paper shredder on
• Set power switch at rear of paper shredder to “I”.
• Paper shredder is ready for operation when green LED on control panel
lights.
Notice
Safety switches are installed at the door and inspection door.
Paper shredder can only be switched on if the door and the inspection
door are both closed.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
6. Scope of delivery
• Paper shredder, ready for connection, in carton packing
• 5 bags for shredded material
• Special cutting block oil (8.4 oz.)
• Operating instructions
Accessories:
• Tray for continuous shredding of computer
• Bag for shredded material
• Special cutting block oil 12 oz., 16 oz., and 1 gallon.
Call for more information.
Shredding paper:
• Feed paper into the paper infeed opening (see “Technical data” for sheet
capacity)
• The shredding process is started by a photo–cell in the paper feeding
opening
• Approx. 3 sec. after the last sheet of paper is pulled in the cutting system
automatically switches off and returns to standby.
The document shredder can also be started by pressing the green arrow
button:
• Press briey:
Cutting device starts.
Automatic stop approx. 3 seconds after the last piece of paper was drawn
in, or manual stop when the stop button is pressed
• Hold down for longer than 2 seconds:
constant operation without light
barrier function.
The cutting device runs until it is switched off with the stop button.
0
I
Switching the paper shredder off
• Set power switch at rear of paper shredder to “0”.
0
I
7. Troubleshooting
Paper jam
You have fed in too much paper.
• Paper shredder jammed.
• Red LED in the key pad ashes.
• Paper shredder reverses automatically.
• Pull paper out of the paper feeding opening.
If material is not completely pushed out, then
• Press dashed arrow button.
• Paper is pushed out.
• Pull paper out.
The cutting device is easily accessible once the inspection door on the top
of the machine is opened.
CAUTION!
Injuries by cutting rollers are possible even when the paper shredder is
idle.
Keep hands away from the cutting system!
• Separate paper stack and feed paper again.
• The shredding process is started again with the green arrow button or by
the light barrier (paper feed).
CAUTION !
Do not press dashed arrow button and green arrow button alternately
forwards and backwards. Cutting system can be damaged.
Electric motor overheated
• Red LED on membrane keyboard lights.
• Paper shredder switches off automatically.
• Allow paper shredder to cool down for approx. 15 to 20 min.
Front door or inspection door on the top of the machine is open.
• Red LED on membrane keyboard lights.
• Paper shredder stops automatically.
• Close front door and inspection door
• If the door is opened when the cutting device is running, the document
shredder must be started again using the green button after the door of
the document shredder has been closed.
Bag for shredded material full
• Red LED on membrane keyboard lights.
• Paper shredder stops automatically.
Reversing the cutting device (“Reverse” button) is also possible even
when the shredded material container is full.

HSM classic Specifications

General

Brand	HSM
Model	classic
Category	Paper Shredder
Language	English