5-26 Pre Operation Checks
Set the switch to “ ” to turn on the high
beam and the taillight.
Set the switch to “OFF” to turn off all the lights.
Turn switch to " " position, the emergency light inside of headlights and tail light are
lit.
CAUTION:
Do not use the headlights with the engine turned off for more than thirty minutes.
The battery may discharge to the point that the starter motor will not operate properly. If
this should happen, remove the battery and recharge it.
Start switch “ ”
The starter motor cranks the engine when this switch is pushed.
CAUTION: See starting instructions prior to starting
the engine. (See pages 6-1—6-2 for details.)
Left/right turning light switch
Move the turning light switch to the right when turning right and to the left when turning
left.
Engine stop switch “ / ”
Make sure that the engine stop switch is set to “ ” before starting the engine. The
engine stop switch controls ignition and can be used at all times to stop the engine,
especially in an emergency. The engine will not start or run when the engine stop
switch is set to “ ”.
Horn switch
Press this switch to activate the horn.
Emergency light switch
Press this switch, Front left/right turning light and Rear left/right turning light blink
simultaneously.
To Next Page
Loading...