As you approach a curve, slow down and begin to turn the handlebars in the desired
direction. As you do so, put your weight on the footboard to the inside of the turn
(opposite the direction you are turning) and lean your upper body into the turn. Use the
throttle to maintain an even speed throughout the turn. This maneuver will allow the
wheels on the inside of the turn to slip slightly, allowing the TRACTOR to make the turn
smoothly.
This procedure should be practiced at slow speeds several times in a large off-road
area with no obstacles. If an incorrect technique is used, your TRACTOR may try to
continue to go straight. If the ATV doesn’t turn as desired, come to a stop and then
practice the procedure again. If the riding surface is slippery or loose, it may help to
position more of your weight over the front wheels by moving forward on the seat.
Once you have learned this technique you should be able to do it at higher speeds or in
tighter curves.
Improper riding procedures such as abrupt throttle changes, excessive braking,
incorrect body movements, or too much speed for the sharpness of the turn may cause
the TRACTOR to tip.
If the TRACTOR begins to tip over to the outside
while negotiating a turn, lean more to the
inside. It may also be necessary to gradually let off on the throttle and slowly steer to
the outside of the turn to avoid tipping over.
Remember: Avoid higher speed turning maneuvers until you are thoroughly familiar
with the operation and feel of your TRACTOR.
Climbing uphill
To Next Page
Loading...