HTC 800 Classic - Changing Grinding Tools; Preparations for Dry Grinding

Usage HTC 800 Classic
16 1.0
4.5.2 Changing grinding tools
1. Remove the grinding tool by giving it a few light taps with a rubber hammer so
the locking mechanism releases, seeFigure 4-5, page 16. Then draw the tool
up out of the guide slot.
Figure 4-5. Removing grinding tools
2. Slide the grinding tool diagonally, from above, down into the appropriate guide
slot on the tool holder, seeFigure 4-3, page 15. Then push the tool fully into
the guide slot.
3. Lock the grinding tool into the tool holder by giving it a few light taps with a
rubber hammer - see Figure 4-4, page 15.
4.6 Preparations for dry grinding
Warning!
Check that the splash guard is fitted.