8 Transportation, storage and disposal
8.1 Transportation
The machine cannot be moved manually if the drive
wheels are locked and the radio control activated. When
lifting the grinder use lifting straps. Attach the lifting
straps in the lifting eye, see figure 1. Only use lifting
straps approved for lifting equipment. Make sure that the
weights are locked in the forward position and that the
handle is in its back position, see figure 1.
Always make sure that the grinder is securely anchored
to its surroundings and the grinding head is lowered
against the surface. Make sure that the securing straps
or other equipment used for anchoring during transport
are tightened over non-moving parts, e.g. the grinder’s
chassis.
8.2 Storage
The machine should be stored in a heated, dry area
when not in use. Otherwise, it may be damaged by
condensation and cold. If the machine is stored in a cold
area (below 0
o
C), it must be kept in a warm area (above
0
o
C) for at least two hours before use.
Always make sure that the grinder is securely anchored
to its surroundings and the grinding head is lowered
against the surface. Make sure that the securing straps
or other equipment used for anchoring during transport
are tightened over non-moving parts, e.g. the grinder’s
chassis.
8.3 Disposal
For recycling and scrapping of components, see the
applicable national regulations for each country. The
machine or machine components can also be returned
to HTC for recycling.
Material Waste manage-
ment
Chassis Electro-galvan-
ised steel
Metal recycling*
Handle Plastic covered
steel
Metal recycling*
Cover Plastic, ABS Plastic recycling/
Combustible
Wheels Metal, plastic and
rubber
Metal recycling*
Grinding head
Lower cover Aluminium Metal recycling*
Cover Plastic, ABS Plastic recycling/
Combustible
External plate
and steel compo-
nents
Electro-galvan-
ised steel
Metal recycling*
Other compo-
nents
Steel
Electrical sys-
tem
Cables Copper conduc-
tors with Neo-
prene and PVC
coating
Waste cable
Motor Metal: Steel, alu-
minium and plas-
tic
Electronic waste
Control cabinet Plastic Metal recycling*
Electrical compo-
nents
Metal and plastic Electronic waste
* Separate the different metal parts, if it is possible.
24 - Transportation, storage and disposal 888 - 001 -
To Next Page
Loading...
