To resume use of the controllers, simply pick them back up. You may need to pair them again
if they become idle.
Setting up multiple play areas
With VIVE Focus 3, you're not just restricted to a single play area. It allows you to set up to 3 play
areas.
Follow the steps in Setting up your play area on page 20 to set up your first play area. Here's how
to set up more play areas:
1. Remove your headset, and then press the Power button to put the system in suspend
mode.
2. Move to the place where you want to set as your second play area.
3. Put the headset back on. It will resume the system automatically.
4. Follow the onscreen instructions to set up your second play area.
5. When done, repeat the above steps to set up your third play area.
There can only be one active play area at a time. Before you change to a different play area, make
sure to put the system in suspend mode first by pressing the Power button. Resume the system
by putting the headset back on or pressing the Power button.
Taking screenshots and screen recordings
You can capture screenshots and record videos of what you're viewing in VR so you can share
them or review them later.
Use the following methods to capture screenshots or record your screen:
Method
Steps
Capture a
screenshot
Do either of the following:
§ Press the VIVE and Trigger buttons on the right controller at the same
time.
§ Press the Headset and Volume down buttons at the same time.
26 Getting the most out of your headset
To Next Page
Loading...
