HTP EFTC-140W User Manual

4
LP-495 Rev. 1.21.16
TABLE OF CONTENTS
PART 1 – PRODUCT AND SAFETY INFORMATION ............................................................................................................................... 4
A. BEFORE OPERATION ...................................................................................................................................................................... 5
B. DURING OPERATION ....................................................................................................................................................................... 5
C. TROUBLESHOOTING AND GENERAL CAUTIONARY STATEMENTS ........................................................................................... 6
PART 2 – MAINTENANCE ........................................................................................................................................................................ 7
A. SERVICE TECHNICIAN .................................................................................................................................................................... 7
B. OWNER MAINTENANCE .................................................................................................................................................................. 7
PART 3 – MAINTENANCE PROCEDURES .............................................................................................................................................. 8
A. DAILY MAINTENANCE – TO BE PERFORMED BY OWNER ........................................................................................................... 8
B. MONTHLY MAINTENANCE – TO BE PERFORMED BY OWNER .................................................................................................... 9
C. 6 MONTH MAINTENANCE – TO BE PERFORMED BY OWNER ..................................................................................................... 9
D. ANNUAL MAINTENANCE – ONLY TO BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN.......................................... 10
PART 4 – TROUBLESHOOTING ............................................................................................................................................................ 10
MAINTENANCE NOTES .................................................................................................................................................................. 11
PART 1 – PRODUCT AND SAFETY INFORMATION
USER – Have this appliance serviced/inspected by a qualified service technician annually.
TO TURN OFF GAS TO THE APPLIANCE
1. Set the thermostat to the lowest setting.
2. Turn off all electrical power to the appliance.
3. Turn manual gas shutoff valve to “OFF”.
Proper care of this appliance is the user’s / owner’s responsibility. The user / owner should carefully read and understand the Operating
Information in this manual before operating this appliance.
It is the user / owner’s responsibility to know the location of the gas shut-off valve and how to operate it. Immediately close the gas
shut-off valve if the appliance is subjected to fire, overheating, flood, physical damage, or any other damaging condition that might
affect the operation of the unit. Have the appliance checked by a qualified technician before resuming operation.
DO NOT use this appliance if ANY part has been under water. Immediately call a qualified technician to inspect the appliance and
replace any part of the control system or gas control which has been under water.
DO NOT power up the appliance unless the gas and water supply valves are fully opened. Make sure the fresh air intake pipe and
exhaust vents are open and functional.
DO NOT attempt to install, repair, or service this appliance. Contact a qualified technician if the appliance needs repair or maintenance.
Ask your gas supplier for a list of qualified service providers.
DO NOT use spray paint, hair spray, or any other flammable sprays near the appliance or near the exterior fresh air intake pipe
termination. DO NOT place any items in or around the exterior exhaust vent termination and/or fresh air intake pipe that could restrict or
block the flow in or out of the vent system.
All safety devices must be tested by the installer / service technician after the appliance is installed.
Always verify proper appliance operation with the service technician after servicing.
The gas ignition system components must be protected from water (dripping, spraying, rain, etc.) during appliance operation and
service (circulator replacement, condensate trap, control replacement, etc.)
The Er:80 code will display when there is no water in the appliance. Ensure the appliance is full of water and all air has been purged
from the system. Then manually reset the appliance to resume operation. If the Er:80 code displays again, call a qualified service
technician to inspect the appliance.
This appliance features a factory installed overheating prevention device. This limit provides appliance shutdown in the event that the
appliance water temperature exceeds the set point of the limit control. Certain local codes require additional water temperature limiting
devices.
FAILURE TO ADHERE TO THE GUIDELINES IN THIS MANUAL CAN RESULT IN SUBSTANTIAL PROPERTY DAMAGE, SEVERE
PERSONAL INJURY, OR DEATH.

HTP EFTC-140W Specifications

General

Brand	HTP
Model	EFTC-140W
Category	Boiler
Language	English