EasyManua.ls Logo

HTP ELU-85WBN - User Manual

HTP ELU-85WBN
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ELU
High Eciency Condensing
Wall-Hung Gas Boilers
DANGER
!
This manual must only be used by a qualied installer / service technician. Read all instructions in this manual before installing.
Perform steps in the given order. Failure to do so could result in substantial property damage, severe personal injury, or death.
NOTICE
The manufacturer reserves the right to make product changes or updates without notice and will not be held liable for
typographical errors in literature.
NOTE TO CONSUMER: PLEASE KEEP ALL INSTRUCTIONS FOR FUTURE REFERENCE.
272 Duchaine Blvd. New Bedford, MA 02745 www.htproducts.com
LP-700 Rev. 000 Rel. 002 Date 4.21.21
WARNING
!
Improper installation, adjustment, alteration, service, or maintenance could void product warranty and cause property
damage, severe personal injury, or death.
California Proposition 65 Warning: This product contains chemicals known to the State of California to cause cancer, birth
defects, or other reproductive harm.
The surfaces of these products contacted by potable (consumable) water contain less than 0.25% lead by weight as
required by the Safe Drinking Water Act, Section 1417.
Heat Exchanger Bears the ASME “H” Stamp
420000510904
Installation
Start-Up
Maintenance
ELU-85WBN
ELU-120WBN
ELU-120WCN
ELU-150WCN models

Table of Contents

Other manuals for HTP ELU-85WBN

Questions and Answers

  • K
    Katherine JohnstonAug 9, 2025
    How to resolve a configuration conflict in my HTP ELU-85WBN Boiler?
    • S
      Stephanie LewisAug 9, 2025
      If you are experiencing a configuration conflict with your HTP Boiler, it means that each boiler connected to the BUS must have a unique address (parameter 0.4.6), and no boiler can be configured as «b-SIN». To resolve this: 1. Press OK, then choose and correct the boiler address. Press OK again. 2. If the above doesn't work, go to parameter 0.4.6 and set the correct boiler address.
  • E
    Erin TylerAug 16, 2025
    What to do if my HTP ELU-85WBN shows a Follower Boiler Missing from BUS Connection error?
    • M
      Meghan MitchellAug 16, 2025
      If the Follower Boiler is missing from the BUS connection, press the Reset button to clear the error code. If the error persists, check the BUS wiring to ensure it is intact and properly connected. Repair if necessary.
  • M
    Melissa HicksAug 25, 2025
    How to configure the address on my HTP ELU-85WBN Boiler?
    • T
      Timothy AdkinsAug 26, 2025
      If your HTP Boiler address is unconfigured, it means the boiler address is undefined (0.4.6 = UNDEF). To fix this: 1. Press OK, then choose and correct the boiler address. Press OK again. 2. If the above doesn't work, access parameter 0.4.6 and set the correct boiler address.
  • M
    Mary WarnerSep 1, 2025
    How to fix a system sensor open short circuit on my HTP Boiler?
    • W
      William MasonSep 1, 2025
      To address a System Sensor Open Short Circuit in your HTP Boiler: 1. Connect the System Sensor to the Master boiler SYS terminal. 2. Check the cable between the System Sensor and the Master boiler. 3. Ensure that the System Sensor is a 10k Ohm NTC. 4. Replace the System Sensor. If the problem continues, replace the main control.

Summary

General Safety Information

Operation and Installation Warnings

General warnings for safe operation and installation practices.

Water Temperature Adjustment and Scalding

Crucial safety information on preventing scalding from hot water.

Prepare the Boiler for Installation

Wall Mounting Instructions

Step-by-step instructions for securely mounting the boiler on walls.

Exhaust Vent and Intake Pipe

Requirements for proper installation of exhaust and intake venting systems.

Carbon Monoxide Detectors

Mandates and guidelines for CO detector installation for safety.

Water Piping

Venting

Approved Materials for Exhaust Vent and Intake Pipe

Specifies compliant materials for safe and durable venting.

Connecting Electrical Service

Wiring

Instructions for proper and safe electrical connections.

Gas Connections

Checking Gas Pressure at the Boiler for Proper Operation

Verifying gas pressure for correct boiler performance.

Controls

Start-Up

First Ignition

Initial steps for powering up and starting the boiler.

Combustion Checking Procedure

Critical steps for verifying and adjusting boiler combustion.

Installation Checklist

Install Exhaust Vent and Intake Piping

Checklist items for venting installation.

Troubleshooting

Boiler Protection Devices

Explains boiler's safety shutdown mechanisms and error types.

Boiler Error Codes

Detailed list of error codes and their possible remedies.

HTP ELU-85WBN Specifications

General IconGeneral
BrandHTP
ModelELU-85WBN
CategoryBoiler
Fuel TypeElectric
Efficiency99.9%
Frequency60 Hz
BTU Input85, 000
BTU Output85, 000
Voltage208/240V

Related product manuals