EasyManua.ls Logo

HTP ELU-120WBN - User Manual

Default Icon
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ELU
High Eciency Condensing
Wall-Hung Gas Boilers
DANGER
!
This manual must only be used by a qualied installer / service technician. Read all instructions in this manual before installing.
Perform steps in the given order. Failure to do so could result in substantial property damage, severe personal injury, or death.
NOTICE
The manufacturer reserves the right to make product changes or updates without notice and will not be held liable for
typographical errors in literature.
NOTE TO CONSUMER: PLEASE KEEP ALL INSTRUCTIONS FOR FUTURE REFERENCE.
272 Duchaine Blvd. New Bedford, MA 02745 www.htproducts.com
LP-700 Rev. 000 Rel. 002 Date 4.21.21
WARNING
!
Improper installation, adjustment, alteration, service, or maintenance could void product warranty and cause property
damage, severe personal injury, or death.
California Proposition 65 Warning: This product contains chemicals known to the State of California to cause cancer, birth
defects, or other reproductive harm.
The surfaces of these products contacted by potable (consumable) water contain less than 0.25% lead by weight as
required by the Safe Drinking Water Act, Section 1417.
Heat Exchanger Bears the ASME “H” Stamp
420000510904
Installation
Start-Up
Maintenance
ELU-85WBN
ELU-120WBN
ELU-120WCN
ELU-150WCN models

Table of Contents

Other manuals for HTP ELU-120WBN

Questions and Answers

  • J
    Jonathan NguyenAug 9, 2025
    How to resolve a configuration conflict in my HTP ELU-120WBN?
    • L
      Lauren SpencerAug 10, 2025
      If you are experiencing a configuration conflict with your HTP Boiler, it means that each boiler connected to the BUS must have a unique address (parameter 0.4.6), and no boiler can be configured as «b-SIN». To resolve this: 1. Press OK, then choose and correct the boiler address. Press OK again. 2. If the above doesn't work, go to parameter 0.4.6 and set the correct boiler address.
  • C
    Charles CruzAug 17, 2025
    What to do if my HTP Boiler shows a Follower Boiler Missing from BUS Connection error?
    • C
      Crystal JohnsonAug 17, 2025
      If the Follower Boiler is missing from the BUS connection, press the Reset button to clear the error code. If the error persists, check the BUS wiring to ensure it is intact and properly connected. Repair if necessary.
  • H
    hollandanaAug 25, 2025
    How to configure the address on my HTP ELU-120WBN Boiler?
    • S
      spageAug 26, 2025
      If your HTP Boiler address is unconfigured, it means the boiler address is undefined (0.4.6 = UNDEF). To fix this: 1. Press OK, then choose and correct the boiler address. Press OK again. 2. If the above doesn't work, access parameter 0.4.6 and set the correct boiler address.
  • E
    Ethan FaulknerSep 1, 2025
    How to fix a system sensor open short circuit on my HTP Boiler?
    • S
      Stacey StephensSep 1, 2025
      To address a System Sensor Open Short Circuit in your HTP Boiler: 1. Connect the System Sensor to the Master boiler SYS terminal. 2. Check the cable between the System Sensor and the Master boiler. 3. Ensure that the System Sensor is a 10k Ohm NTC. 4. Replace the System Sensor. If the problem continues, replace the main control.

Summary

General Safety Information

Operation and Installation Warnings

Key warnings for safe operation and installation.

Prepare the Boiler for Installation

Wall Mounting Instructions

Detailed steps for securely mounting the boiler to various wall types.

Exhaust Vent and Intake Pipe

Requirements and methods for installing the exhaust and intake venting system.

Venting

General

Critical safety and installation requirements for the boiler's venting system.

Approved Materials for Exhaust Vent and Intake Pipe

Lists approved materials for vent and intake piping systems.

Connecting Electrical Service

Wiring

Instructions for connecting the boiler's electrical power supply safely.

Gas Connections

Start-Up

First Ignition

Step-by-step guide for initial boiler ignition and startup.

Combustion Checking Procedure

Critical procedure for verifying and adjusting combustion performance.

Troubleshooting

Boiler Protection Devices

Explanation of boiler protection mechanisms and error codes.

Boiler Error Codes

Detailed list of boiler error codes and their possible remedies.

HTP ELU-120WBN Specifications

General IconGeneral
BrandHTP
ModelELU-120WBN
CategoryBoiler
LanguageEnglish

Related product manuals