To Next PageTo Next PageHow to resolve a configuration conflict in my HTP Boiler?
If you are experiencing a configuration conflict with your HTP Boiler, it means that each boiler connected to the BUS must have a unique address (parameter 0.4.6), and no boiler can be configured as «b-SIN». To resolve this: 1. Press OK, then choose and correct the boiler address. Press OK again. 2. If the above doesn't work, go to parameter 0.4.6 and set the correct boiler address.
What to do if my HTP ELU-150WCN shows a Follower Boiler Missing from BUS Connection error?
If the Follower Boiler is missing from the BUS connection, press the Reset button to clear the error code. If the error persists, check the BUS wiring to ensure it is intact and properly connected. Repair if necessary.
How to configure the address on my HTP Boiler?
If your HTP Boiler address is unconfigured, it means the boiler address is undefined (0.4.6 = UNDEF). To fix this: 1. Press OK, then choose and correct the boiler address. Press OK again. 2. If the above doesn't work, access parameter 0.4.6 and set the correct boiler address.
How to fix a system sensor open short circuit on my HTP Boiler?
To address a System Sensor Open Short Circuit in your HTP Boiler: 1. Connect the System Sensor to the Master boiler SYS terminal. 2. Check the cable between the System Sensor and the Master boiler. 3. Ensure that the System Sensor is a 10k Ohm NTC. 4. Replace the System Sensor. If the problem continues, replace the main control.
General warnings for boiler operation and installation.
Information regarding potential issues with improper combustion.
Safety considerations related to gas supply and handling.
Safety precautions to be taken when servicing the boiler.
Information on adjusting water temperature and preventing scalds.
Required clearances around the boiler for maintenance and service.
Step-by-step instructions for wall-mounting the boiler.
Detailed steps for mounting the boiler on a concrete wall.
Detailed steps for mounting the boiler on a wood-studded wall.
General information about the exhaust vent and intake pipe system.
Requirements for installing carbon monoxide detectors.
Instructions for direct venting of exhaust and intake pipes.
Guidelines for power venting with indoor combustion air.
General safety and installation requirements for venting systems.
Guidelines for the proper placement of vent and intake terminations.
Detailed steps for installing exhaust and intake vent pipes.
Overview of different venting applications and system configurations.
Instructions for direct venting of exhaust and intake pipes.
Instructions for wiring the boiler and its components.
How to check for gas leaks before and during operation.
Step-by-step guide for the initial ignition of the boiler.
Procedure for checking and adjusting combustion parameters.
Explanation of boiler protection devices and error types.
A list of boiler error codes and their possible remedies.
General