HTP UFT-199W - User Manual

272 Duchaine Blvd. New Bedford, MA 02745 www.htproducts.com
LP-542 REV. 6.2.16
Universal Fire Tube Boiler
Wall Mount
INSTALLATION
START-UP
MAINTENANCE
PARTS
WARRANTY
Models
UFT-80W / 100W / 120W / 140W / 175W / 199W
Heat Exchanger Bears the ASME “H” Stamp
NOTICE: HTP reserves the right to make product changes or updates without notice and will not be held liable for typographical errors
in literature.
NOTE TO CONSUMER: PLEASE KEEP ALL INSTRUCTIONS FOR FUTURE REFERENCE.
IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLOSION MAY RESULT, CAUSING
PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE. DO NOT STORE GASOLINE OR OTHER FLAMMABLE VAPORS
AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER BOILER.
WHAT TO DO IF YOU SMELL GAS
 Do not try to light any appliance.
 Do not touch any electrical switch.
 Do not use any phone in your building.
 Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
 If you cannot reach your gas supplier, call the fire department. Installation and service must be provided by a qualified installer,
service agency, or the gas supplier.

HTP UFT-199W Specifications

General

Brand	HTP
Model	UFT-199W
Category	Boiler
Language	English

Summary

PART 2 - SAFETY REGULATIONS

A. OPERATION AND INSTALLATION WARNINGS

Critical safety precautions for operating and installing the boiler.

B. IMPROPER COMBUSTION

Guidelines to prevent unsafe combustion and related hazards.

F. BOILER WATER CHEMISTRY

Essential water quality parameters for efficient boiler operation.

PART 4 - PREPARE BOILER LOCATION

B. BEFORE LOCATING THE BOILER

Key considerations and warnings before selecting the boiler's installation site.

D. CLEARANCES FOR SERVICE ACCESS

Required clearances around the boiler for safe maintenance and operation.

G. PREVENT COMBUSTION AIR CONTAMINATION

Critical measures to prevent contamination of combustion air.

I. WALL-MOUNTING THE BOILER

Instructions and warnings for securely mounting the boiler on a wall.

PART 5 - VENTING

A. INTAKE PIPE AND EXHAUST VENT GUIDELINES

Comprehensive rules for installing intake and exhaust vent systems.

E. VENT TERMINATION

Requirements for proper termination of vent pipes.

1. Direct Vent, Two Pipe Roof and Sidewall Vent Terminations

Specifics for direct vent termination types.

4. Power Vent, Indoor Combustion Air Installation in Confined or Unconfined Space

Installation methods for power vent systems using indoor air.

PART 9 - CONNECT ELECTRICAL POWER; INITIAL STARTUP

D. WIRING A CASCADE SYSTEM

Instructions for connecting multiple boilers in a cascade configuration.