9. GUARANTEE/WARRANTY
7. START-UP
8. OPERATION
– if the device is no longer functional
This applies:
– in the event of transport damage
– if the device shows visible damage
If it is assumed that safe operation is no longer possible, the device must be
decommissioned and secured against unintentional operation.
After the device and the coils have been attached and fixed, the device can be put
into operation. To do this, plug the power cable into a proper 230 V/50 Hz protective
contact socket. The green operating light must now light up. After being connected
to the power supply, the device immediately starts working in a previously saved
mode. This can be recognized by the fact that the display for the corresponding
frequency range flashes permanently.
– if the connecting cables show visible damage
DISTURBANCE
The dealer/manufacturer from whom the device was purchased provides a warranty
of 2 years from delivery for the material and manufacture of the device. In the event
of a defect, the buyer initially only has the right to subsequent performance. The
supplementary performance includes either the subsequent improvement or
– if parts of the device are loose or loose
By pressing the “MODE” button, the output frequencies can be set manually. Each
time you press the button, the frequency range is increased by one step. If the button
is not pressed again within the next 10 seconds, the device saves the new setting.
The set frequency is then applied to the coils. In automatic mode, the “Automatic”
LED lights up and the LEDs responsible for the respective frequency range switch
cyclically. The voltage frequency on the coils changes smoothly from the minimum
to the maximum value within 0.1 seconds (10 Hz modulation), which is valid for this
range.
PROFICALK10
Machine Translated by Google
To Next Page
Loading...