– Before putting a device into operation, it is generally necessary to check whether
this device or assembly is fundamentally suitable for the application for which it
is to be used! If in doubt, it is essential to ask specialists, experts or the
manufacturers of the components used!
– Components, assemblies or devices may only be put into operation if they have
previously been installed in a housing so that they are safe to touch. They must
be de-energized during installation.
Please note that operating and connection errors are beyond our control.
Understandably, we cannot accept any liability for any damage resulting from this.
– Tools may only be used on devices, components or assemblies if it is ensured
that the devices are disconnected from the supply voltage and that electrical
charges stored in the components in the device have previously been discharged.
Important NOTE!
– Live cables or lines to which the device, component or assembly is connected
must always be inspected for insulation defects or breaks. If a fault is discovered
in the supply line, the device must be taken out of operation immediately until
the defective line has been replaced.
– Before opening a device, always pull out the power plug or make sure that
In the event of static discharge, the operating status of the device can change!
– If an existing description does not clearly indicate to the non-commercial end
user which electrical characteristics apply to a component or assembly, how
external wiring is to be carried out, or which external components or additional
devices may be connected and which connection values these external
components have If you are allowed to do this, you must always ask a specialist
for information.
the device is without power.
5 PKS 2000 PLUS X
3. GENERAL SAFETY INSTRUCTIONS
Machine Translated by Google
To Next Page
Loading...