PROFIKALK PKS 2000 PLUS X
With a correctly selected frequency range (from 1 to 5), the efficiency of the
device can be up to 30% higher than in automatic operation. Which resonance
frequency is the right one for a particular water system depends on various
factors: flow speed of the water, water hardness, material and diameter of the
water pipes, etc. and can only be determined experimentally.
4. 12.000…16.000 Hz
3. 8.000…12.000 Hz
– Modulation: 10 Hz
2. 4.000…8.000 Hz
– Frequency range: var. 1…32 kHz
Outputs: 2 x capacitive
6 output frequencies: 1.
1,000…4,000 Hz
– Nennaufnahme: max. 1.5 Watts
TECHNICAL DATA
– Capacity: up to 5 m³/h
– Pipe diameter: up to 50 mm
– Rated voltage: 230V/50Hz
6. Automatic (1,000...32,000 Hz)
5. 16.000…32.000 Hz
– Impulse cable: approx. 2 x 1.8 m
2
PROFICALK
This electronic, microprocessor-controlled device largely
reduces limescale deposits in water pipes, hot water devices,
heating elements, etc. Even old limescale deposits
can be broken down and rinsed out over time. There is no
need to intervene in the pipe system for installation.
The device incurs few operating costs and is sufficiently
dimensioned for water consumption of up to 5 m3/h. It can
be individually adapted to the respective pipe system.
Machine Translated by Google
To Next Page
Loading...