3
Indicator Light
Battery
Compartment
Indicator Light: flashes once meaning the motion sensor was activated
and sent the wireless signal.
Battery Compartment: please insert 3 pieces AA 1.5V Alkaline batteries
(not included).
Sensitivity Jumper : Factory default is Low sensitivity, if you want to
select High sensitivity, please take out the jumper slightly by the plier
first, and insert the jumper back to the left two needles.
Sensitivity
Jumper
2. Operation Instructions
Step 1
Plug the receiver into an outlet.
The indicator light of the receiver will flash once
and a beep prompt meaning normal operation.
To Next Page
Loading...