Step 1
Plug the receiver into an outlet.
Step 2
Press and hold both the “Volume” button and “Melody” button for
10 seconds and release the buttons when you hear a long beep prompt;
Note: all the sensors will be deleted by this operation.
Volume
Step 4
has been added to the receiver already.
Activate the sensor again to confirm the sensor
Step 5
total 35 melodies optional.
(2)How to delete the sensors of the receiver
Press”Melody”button to choose the melody for this sensor.
flashing quickly
(a ring tone prompt and the indicator
light flashes quickly meaning the
sensor has been added to the plug-in
receiver successfully)
Melody
1 foot waya
9
(the indicator light will flash once
meaning the motion sensor was
activated and sent the wireless signal)
To Next Page
Loading...