Huawei AISU - Resetting the AISU; Deleting an AISU

AISU
User Manual
5 Configuration Guide
Issue 02 (2017-06-12)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
31
----End
Resetting the AISU
You can run the RST ALD command to reset the AISU. If the AISU is reset by running this
command, antenna engineering parameters saved are not affected.
Procedure
Step 1 In the parameter input area, enter RST ALD in Command (F5), and then click Assist or
press Enter.
Step 2 In the parameter input area, specify related parameters.
The parameter values in the following figure are for reference only.
Step 3 Press F9 or click Exec.
If Operation succeeded is displayed in the command export area, the AISU is reset
successfully. If the AISU fails to be reset, identify causes and reset the AISU again.
----End
Deleting an AISU
You can run the RMV RAE command to remove the AISU.