9
Do not connect cables while the power is on.
Do not power on the router before you finish connecting and routing cables.
Invisible laser beams will cause eye damage. Do not look into bores of optical modules or connectors of
optical fibers without eye protection.
WARNING
For details about pin assignments and cable connections, see the Hardware Description.
NOTE
5.1 Connecting the AR530 Series Industrial Switching Router
Connecting the Router
No.
1
2
3
4
5
6
7
Item Connect To Remarks No. Item Connect To Remarks
External power
supply system
M4 lug: to the router
M6 lug: to the
protection ground
Terminals like
electric meters and
digital input devices
Up stream
network device
The combo interface
consists of an FE
optical interface and
an FE electrical
interface.The optical
fiber must be used
with an optical
module.
Switch or PC
Maintenance
terminal
(generally a PC)
USB flash drive
Connect to an
electrical interface
to receive and
send data services.
M4 lug: the end with a
smaller hole
M6 lug: the end with a
larger hole
When the router is
powered on for the
first time, connect the
console interface to a
PC for onsite
configuration.
Ground cable
4-pin AC power
cables
Ethernet cable
RS485 and DI
cables
Optical fiber
Ethernet cable
Console cable
USB extension
cable
Some industrial
switching router
models use DC power
supply. Connect 2-pin
DC power cables to
these routers. Ensure
correct correction of
the positive and
negative cables.
—
—
CONSOLE
RESERVE FE0
RST
L1 L2 L3 N
A
RS485-0
BA
RS485-1DI-0DI-1
B
GE0
RX TX
GE1
MONITOR
RX TX
FE2 FE4
FE1 FE3 FE5
FE6
Power outage Survival
FE7
L1 L2 L3 N
1A
1B
2A
2B
4
76
23
18
5
To Next Page
Loading...
