8
4.3 Installing a 180 W PoE Midspan
Place the rear panel of the 180 W PoE midspan in front of the DIN rail and ensure that the DIN rail fits in
between the fixture near the top of the PoE midspan and the spring latch near the bottom.
1
Make the 180 W PoE midspan incline forward with the bottom away from the DIN rail, and place the fixture
at the rear of the 180 W PoE midspan on the top of the DIN rail.
Slowly push the PoE midspan toward the DIN rail to make the spring latch at the rear of the PoE midspan
move down. The spring latch then bounces back to fix the PoE midspan on the DIN rail.
2
3
NOTE
Before the installation, ensure that the DIN rail has been secured in position.
Place the 180 W PoE Midspan near the DIN rail for convenient movement.
NOTE
If the spring latch is too tight to move down, you can pull down the spring latch during the installation.
NOTE
If the spring latch is too tight to move down, you can pull down the spring latch during the installation.
Installing the 180 W PoE Midspan on the DIN Rail
To Next Page
Loading...
